The file is a pre-set qPCR program to run a plate filled with water used to test the basic raw fluorescence signal of AriaMx Optical modules.
File required for Performing a Background Calibration
The GC cycle time should be the time from injection until the GC is ready to run again. This includes the analysis run, cool down, and equilibration. Based on the times you listed, it would be roughly 40 minutes. It may be worth timing to make sure. The…
Hi howard_sanford, my apologies for a slow response, but thank you very much for the help and advice. I was able to get the filter for Cal and CC to work, and I appreciate the discussion of my larger problem. I think I'm probably several (many) steps…
Hello, thank you for your help. I had tried loading different processing methods but I didn't realize the results were not linked to any method. It turns out the result files were read-only and could not be linked to any method. I moved the result files…
The peaks look similar, essentially the same sensitivity. I'd look at the background on your older runs and the background now. It could be that most of the previous background was one, two, a few, ions and they're gone now. Was that small but still noticeable…
That is one failure mode of Platinum Resistance Thermometers. It can happen one degree to the next higher degree. The heater/sensor must be replaced, part number G1099-60107.
See also: (+) AUX 2 heater fault - Forum - GC/MS - Agilent Community
This Information Applies To: Agilent GC Systems with Flame Ionization Detector (FID)
Issue:
The Flame Ionization Detector (FID) jet could become clogged with ferrule material, column bleed, or heavy molecular analytes. The clogged jet will affect...
This Information Applies To: Agilent GC Systems with Split/Splitless (S/SL) inlet
Issue
Different liners are required for different high concentration, split analysis techniques including:
General use liners
Auto inject, general use
Auto...
This Information Applies To: Agilent GC Systems with Split/Splitless (S/SL) inlet
Issue
Different liners are required for different splitless trace analysis techniques including:
General use liners
Pressure, temperature, volume (PTV)
Hot...
This Information Applies To: Agilent 6890, 7890, 7820, 8890 and 8860 GC Systems with Split/Splitless (S/SL) inlet
Issue
Replacement of the Gold Seal is required as part of inlet maintenance. Replacement is required when the performance of the inlet...
This Information Applies To: Agilent GC Systems with Micro-ECD.
Issue
The Wipe Test is an annual test that performed by end user of the micro-ECD (Micro Electron Capture Detector or uECD) to help ensure radioactive safety when using the detector...
This Information Applies To: Agilent GC Systems with thermal conductivity detector (TCD)
Issue
Baking the thermal conductivity detector (TCD) at high temperatures can remove sample contaminants that have deposited on the detector surfaces.
Items...
This Information Applies To: Agilent GC Systems with flame ionization detector (FID)
Issue
Baking out the flame ionization detector at high temperatures can remove sample contaminants that have deposited on the detector surfaces.
Items required...
This Information Applies To: Micro Electron Capture Detector (uECD)
Issue
Baking the micro electron capture detector (µECD) at high temperatures can remove sample contaminants that have deposited on the detector surfaces.
Warning ...
This Information Applies To: Agilent GC Systems with Flame Ionization Detector (FID)
Issue
This article will describe how an operator can configure the makeup gas on both the instrument keypad and the software driver (Method Editor).
Background...
This Information Applies To: Agilent HPLC systems
Issue
The presence of ghost peaks can be a symptom of a system contamination issue, caused by accumulation of sample and/or foreign substances in the flow path. It is critical for high sensitivity...