This is a discussion with Rob Dejong, Agilent's Micro GC Product Manager. We discuss hydrogen energy and how the Micro GC can be used to analyze hydrogen fuel blended with natural gas. Hydrogen energy is an exciting topic as it is a big part of the green…
Hi aline.castilla-vitkovsky
Better to create the methods in the 8890 from the default method, (default.m).
If the version of the software are different you may have problems with it.
Thanks
Regards
Support and educational resources for VWorks Automation Control Software for Liquid Handling including VWorks Standard and VWorks Plus (compliance-enabled).
Support Documents
Automation Solutions Help and Learning
Automation Software and Devices…
Hello,
Agilent stopped supporting Galaxie in 2014 so we no longer provide the software. Attached was the note announcing the discontinuation. OpenLan CDS 2.x can support certain versions of the 490 GC. You might also have options with OpenLab EZChrom…
Hi Chelsea!
That column was hidden. I didn't even know there were more columns available there and, sure enough, the "Level 1" was missing. Not sure what happened to it, but that's an easy fix.
Thank you for your help!
Jacob,
I am new to chemstation software and trying to learn it. I am having the same problem using the same method. I am testing hemp. Did you figure out why you were getting incorrect potency? Also, are you using (Multipliers = 20, 20. Dilution factors…
It is less volatile, but should work from your aqueous medium. Incubation temperature 80-90 °C, incubation time 10-20 minutes. With a SPME PDMS fiber (10%) you could even improve it more.
Hi Nadjan, I have some good news . I ordered a drain management kit G4267-68708. I replace the only washport in G7167A, and it successfully completed the autoreferencing. You were right, it is all due to washport, I did not change the whole drain kit…
This Information Applies To: Agilent HES source, Agilent 5977 Series GC/MSD
Issue:
During normal operation of the GC/MSD, the source will require cleaning. It is time to clean the source when:
There is a loss in analyte response not improving...
This Information Applies To: Agilent 5977 and 5975 Series GC/MSD systems
Issue
The autotune fails and reports the error Tune action stopped: Gain and offset = 0 and peaks are too narrow!
Resolution
The MSD autotune program is run after routine...
This Information Applies To: Agilent ICP-MS systems (7700/7800/7850/7900/8800/8900)
Issue
Condition new or cleaned ICP-MS skimmer cones and sampler cones by aspirating a Conditioning Solution before use.
Background
Drift up can be a sign of...
Turn On the GC/MS Interface and Oven Using OpenLab CDS
Multiple Results
This Information Applies To: Agilent GC/MS instruments controlled by OpenLab CDS software
Issue
Turning on the GC/MS interface heater and Oven using OpenLab CDS software.
Steps to Follow
From the Home tab, click Method > Instrument Setup...
This Information Applies To: Agilent ICP-MS systems (7700/7800/7850/7900)
Issue
The signal monitor function in MassHunter can help with troubleshooting low sensitivity, carry over, contamination, or high background. It can also be used to optimize...
This Information Applies To: Agilent UV detectors (Variable Wavelength Detectors, Multiple Wavelength Detectors, and Diode Array Detectors)
Issue
Checking accumulated hours on the UV lamp.
Steps to Follow
There are four ways to check the accumulated...
This Information Applies To: Agilent 7700/7800/7850/7900/8800/8900 ICP-MS
Issue:
Poor internal standard (ISTD) mixing can cause high relative standard deviation (RSD).
The recommendations in this article are applicable if:
It takes a long...
This Information Applies To: Parallel capillary electrophoresis platforms, 5200/5300/5400 Fragment Analyzer, ZAG DNA Analyzer, Femto Pulse, Oligo Pro II
Issue:
Disposing used capillary arrays
Resolution:
Arrays can be discarded in regular...
This Information Applies To: 5200, 5300 and 5400 Fragment Analyzer, ProSize software, DNF-471 RNA kit, DNF-472 HS RNA kit
Issue:
The DV 200 score is a quality score for evaluating quality of RNA derived from formalin-fixed paraffin-embedded (FFPE...
This Information Applies To: 5200/5300/5400 Fragment Analyzer, Femto Pulse, and ZAG DNA Analyzer
Issue:
Dirt or dust on the capillary array window can cause baseline shifts or elevation of the baseline. Figure 1 shows an example electropherogram...