The Digest of upcoming webinars has been updated as of July 17.
Check out the Perfect Your PFAS Workflows webinar series here .
Notable additions include:
PFAS (2)
Check Out:
Analysis of Multiple Elements in Lithium Salts using an Autodilution…
Category/Series
Recorded/Upcoming Date
Recording Link
Atomic
7/23/2024
Analysis of Multiple Elements in Lithium Salts using an Autodilution ICP-OES Workflow
Atomic
8/6/2024
Elemental Analysis of Lithium-ion Battery Samples…
Thank you for your reply. I have not worked much with Gas GCs and I am not that familiar with different parts of it. I have performed leak check around front inlet and inside oven compartments (around columns). There was no leak. Could you please show…
The May 2011 issue of Dissolution Technologies ( https://dissolutiontech.com/DTresour/BackIssuefldr/BackIssuesfrmst.html ) compiles a lot of the thoughts of various agencies regarding the use of the alternate MQ procedure. MQ does have acceptance in most…
This is normal as PONA columns are apolar phases with thin films. For your light HC's < C5 either a thick film (ca. 5 µm) or another phase/column would help, but higher HC's cannot be done then (see also Lance's answer). It's either switching or backflushing…
Hi xiangui Are you running different methods in different worklists, or are the worklists all running the same method? I assume the same method across worklists, but this is not clear in your question.
Does this change in pressure lead to a change in…
This Information Applies To: Agilent MassHunter Qualitative Analysis software version 10.0
Issue
Introduction to MassHunter Qualitative Analysis for Agilent GC/MS – Navigator View.
Steps to follow
Note : Use the demonstration data...
This Information Applies To: All versions of Agilent MassHunter Qualitative Analysis Software , and Agilent MassHunter Quantitative Analysis version B08.00 and up
Issue
Calculation of signal-to-noise in MassHunter is performed using the same parameters...
This Information Applies To: Agilent GC/MS MassHunter Data Acquisition Software
Issue
Preparing and running a sample is essential for data acquisition. The steps below detail how to run a single sample using an Automatic Liquid Sampler (ALS) on...
This Information Applies To: Agilent MassHunter Qualitative Analysis Software version 10.0
Issue
Introduction to MassHunter Qualitative Analysis for Agilent GC/MS – Compound View.
Steps to follow
Note : Use the demonstration data files...
This Information Applies To: Agilent MassHunter qualitative analysis software
Content:
MassHunter can be configured to label TIC chromatographic peaks with the best match compound name from an MS library search.
Steps to follow:
On the top...
This Information Applies To: Agilent MassHunter GC/MS Data Acquisition (Rev. 10.0 and below)
Issue
Users running MassHunter GC/MS Data Acquisition with Microsoft Windows 10, may encounter warning messages about insufficient memory in the PC when...
This Information Applies To: Agilent MassHunter Qualitative Analysis Software, Revision 7 and up
Issue
This article shows the procedure to change the number of decimal places in the Mass Spectrum Preview and MS Spectrum Results windows of the MassHunter...
This Information Applies To: Agilent OpenLab CDS ver. 2.4 or earlier.
Issue:
If the PC name on a system with OpenLab 2.4 or earlier revisions needs to be changed post installation of the software. This must be done in the right way or the instrument...
This Information Applies To: Agilent OpenLab CDS Software (ver 2.x).
Issue:
This article will give instructions on how to submit a single sample run in the OpenLab CDS Software.
Steps to follow:
Launch the acquisition software through the...
This Information Applies To: Agilent OpenLab CDS products
Issue:
Every computer running Agilent OpenLab CDS Software requires a unique software license for continuous operation. Failure to install a valid license will cause the instrument control...