Display grouped peak summary in sequence summary reports

Hello,

Which software are you using (Chemstation, CDS 2.x, EZChrome)?

Marty Adams

CDS 2.X

Hello,

In CDS 2.x you will need to setup the BKC as a timed group if you want to be able to calibrate using the summed area. Also in the standard summary report you will need to remove the filters that restrict compound type 3.

Marty Adams

Thank you This looks like what I am after I am just not sure how to implement this piece. 

I open a processing method, Identify the peaks of interest (for this example peaks are at 9 and 10 minutes. Also I create a timed group where I add these peaks as well. When in Data processing if I display injection results, the combined peak area displays on the screen.  

However when I go to edit a report I cannot make a report display this information. Can I get very detailed instructions for this part? This is where I am struggling as I am not familiar with the reporting section of the software. 

Thank you This looks like what I am after I am just not sure how to implement this piece. 

I open a processing method, Identify the peaks of interest (for this example peaks are at 9 and 10 minutes. Also I create a timed group where I add these peaks as well. When in Data processing if I display injection results, the combined peak area displays on the screen.  

However when I go to edit a report I cannot make a report display this information. Can I get very detailed instructions for this part? This is where I am struggling as I am not familiar with the reporting section of the software. 

Marty, 

how do I remove the restrictors? Thank you Bob 

Hi Bob

In the report template, you need to add a "Summed Peaks" table

/Andy

Andy,  Thank you for the help. I took the default "Sequencesummary_short_letter.rdl and added this table to that report. (at the bottom) I get only 

How do I get this to report all of the samples that were run? Sorry very new to this. 

You're right, this report item is designed for a single injection report.

To change it is a little complicated, but I will try to help.  It is simplest if you only have one Timed Group.

Select the group containing the data

Right-click to see its properties

You will see that the group is repeated for each Compound_ID.

Change this to repeat for each Sample_ID

Now you need to change the textbox that currently shows Compound_Name to show Sample_Name

Right-click to access the properties of this text box

Click on the fx button to select Sample_Name instead of Compound_Name

Make sure you have all of the samples selected and preview the report.  You should get something like this (I'm using example data here)

Hope that helps.

/Andy

Andy, Thank you I was able to follow your directions and I am now able to recreate this table. Thank you. I will now "attempt" to format the table so it appears like the other default tables that Agilent uses. Thank you again! I am sure I will be back with more ?'s 

Andy, Thank you for the help with this table. I do have an additional request if that is possible? I can now display the calculated results of the combined peaks and that works fine. However is there a way to display this information in a traditional sample table (first table below)? Please see pics below. The screenshot is a typical table for a compound. This is how I would like the combined data to display, If possible can you provide the steps for this activity. Also, how do I display only the sample statistics and not blanks ,sys suit, or cal stds?