No turbo vac reading at parameter section from diagnostics program_G6230 TOF

Young 11 months ago

Hello,

Thanks for your help in advance!

Our G6230 TOF was suddenly vented by itself once the instrument detected "insufficient high vacuum [69]". So, today morning I restarted TOF instrument and performed the manual-recommended start-on (pumping down + 8 hr HV conditioning) using a diagnostic tool program.

Then, I found out that there is no vacuum reading from Turbo 1 at the parameter section from the diagnostics tool.

However, I can see TOF vacuum reading at the SC readbacks section.

Are there anyone who is familiar with this issue?

I also wonder whether this issue is related to the error showing up last Saturday or not.

Thanks!

Young

Parents

richeinz 11 months ago

Hello,

You have to start masshunter and have a successful initialization of the TOF before Diag will display the correct High vacuum values.

Reading of low 10E-08 means that the gauge is still Off
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Young 11 months ago in reply to richeinz

Thanks for your advice.

Last week, the instrument succeeded HV conditioning, but it vented again due to the same error.

Then, I restarted MS, and started masshunter before opening up Diagnostics. However, the gauge is still off.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Young 11 months ago in reply to richeinz

Thanks for your advice.

Last week, the instrument succeeded HV conditioning, but it vented again due to the same error.

Then, I restarted MS, and started masshunter before opening up Diagnostics. However, the gauge is still off.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data

Was this helpful?