SPS 4 autosampler

Hi Lucas_S welcome to the Community!

I moved your question to the Atomic Spectroscopy Forum for better visibility.

Cheers,

Kristen

Thanks!

Hi Lucas,

what software are you using to control the SPS4 Masshunter (ICP-MS) or ICP Expert (ICP-OES) or any other?

cheers 

Chris

Hi Chris,

I am using Masshunter...

Hi Lucas,

sorry not to have a positive answer for you, but with Masshunter it is not possible, to define new rack designs. 

Maybe you can use a preset and manually test, which vial positions reflect your needs.

Greets

Chris

Hi Chris, I would like to set up a rack for small volume samples, I already use the option using the 96-well plate on this autosampler, however, this option is too small volume (< 400 uL), I would like to work with microanalyses but with around 1 mL directly in the empendorf tubes, the autosampler has the option of a rack with 90 positions, but the calibration in the SPS 4 is very bad, even if the autosampler calibration is performed with this rack (90 position), the needle hits the side of the extreme positions, I can only use some positions of the rack (less than 50% of the positions), the autosampler calibration of this autosampler is simply does not work for the 90 position rack. I have 3 ICPs here with this autosampler (SPS 4) and it just doesn't work for the 90-position rack, I can only use the 21- and 60-position racks if I want to use all holes without problems....