This Information Applies To: Agilent 6400 Triple Quadrupole LC/MS systems, MassHunter Workstation 10.1 or below. This procedure does not apply to MassHunter Workstation 12.0 or above .
Issue
Fully reset the LC/MS triple quadrupole system via MassHunter Workstation 10.1 or earlier.
For users who...
This Information Applies To: Agilent 6200 Series TOF and 6500 Series Q-TOF Systems
Issue
Instructions on how to correctly dilute the tune mix for 6200 Series TOF and 6500 Series Q-TOF systems depending on source type.
Background
If the Tune Report shows calibration abundances greater than...
This Information Applies To: Agilent 6400 Series triple quadrupole LC/MS systems
Issue
Autotune fails to complete.
Background
Agilent 6400 LC/MS systems use an Autotune algorithm to optimize the sensitivity and mass resolution of the instrument. Sometimes when running the autotune procedure...
This Information Applies To: Agilent 6200/6400/6500 Series LC/MS Systems
Issue
Instructions on how to fill the calibrant bottle on 6200/6400/6500 Series LC/MS Instruments when calibrant levels are running low.
Background
The ability to autotune your Agilent LC/MS system relies on providing...
This Information Applies To: All Agilent 6000 Series LC/MS Systems without a gate valve for ion capillary installation/removal.
Issue:
Installing the Ion Transfer Capillary after cleaning or replacement. For instructions for installing an ion capillary on LC/MS instruments with a gate valve installed...