masshunter report builder about qualifier peak show to peak overlay in graphics

Question

dear everyone 
 i have a question. 
 qualifier peak show to peak overlay in graphics. 
 but i want show single or separation qualifier peak and show Q-ratio in below picture . 
 can i how to doing

howard_sanford · Answer

Hello jeremy_lai , 
 If you want to add the QualifierPeak graphic, you will need to add a binding for the qualifier and then reference that in the Qualifier ID section under properties. There is an example of how to do this in the template attached. For reference this was originally posted in the following discussion. 
 (+) Struggling with report builder for MassHunter Quant 10 - Mass Spectrometry Software User Forum - Mass Spectrometry Software - Agilent Community 
 Gen_ResultsSummary_TEST05.template.xml.zip