QC Setup in Quantitative Analysis

create new "calibration level" with concentration of your QC

Thank you for the response. Can you please clarify the steps to set this up correctly?

In my batch table I setup my sample type as QC with a level of QC1. When I go to my method concentration setup table and add a New Calibration Level (by right clicking on the table), it defaults to "Calibration" as Type and I'm not able to change it to a QC sample. 

Hello onestone ,

I am observing this behavior as well in the method editor. But it appears that as long as you add the level name in the method concentration setup and it matches to a QC type in the batch table, when you exit and analyze the batch it will automatically be changed to a QC in the concentration setup table. 

Another way to update this would be to use the Calibration Curve option to Create Levels from Calibration Samples. Though depending on your batch/sequence/worklist setup you may need to re-enter the concentrations for all levels. 

Basically you must create standard calibration level with level name as you wish, and u will not use this level for calibration, but only for comparing your QC in batch table with this "calibration level". 

Basically you must create standard calibration level with level name as you wish, and u will not use this level for calibration, but only for comparing your QC in batch table with this "calibration level".