Calibration curve from previous working method not linear on new GC/MS

Below is a link to the GCMS Familiarization Guide.

https://www.agilent.com/cs/library/usermanuals/public/G3335-90200MSDFamiliarization-en.pdf

We have Mass Hunter 10.2 version. I am new scientist working on this GC-MS Agilent. When I am creating a batch table sequence but the sequence save as option is not coming. For me create method file no problem. Even though sample sequencing finish no problem when I want to save Okay. Software asking me method file but we already loaded method file. Then I uploaded method file asking me sample file. However, I could not find the save sequencing table. If I give the file name and vial number then run the samples on that selected sample file. After finished run then error comes. Therefore, something is hiding in the manual. I am ready need someone help to solve this problem.     

I do not know how to solve the problem

Hello dramzadh ,

That warning means that the calibration level name in your batch table does not match the level name in your calibration table.

To resolve this, after you create your batch and add samples make certain that your calibrators are specified and that they have level names. If you set this up in your sequence table it should come over from there. If not, you can edit and change this in the batch table.

The Level also has a drop down available, but you can just type over or enter a new name if it is blank. The Level is actually text, and can be anything you like, though most customer stick with 1,2,3, etc. or L1, L2, L3, etc. The only thing that matters is that the levels in the batch table must exactly match the entries in your method calibration setup.

You can add the Type column to help see how the levels match up if you have multiple calibrator types.

The best way to make certain that the level names match is to use the option in the method editor to create levels from calibration samplers.

If your sample Type and Level are set correctly in the batch table, then this will make your method match exactly. 

Dear Colleague 

Good morning. I have create the method and sequence. Save the sequence and load sequence it run one sample then errors is coming. When I click dismiss then automatically closed the program. So I have to run the sample one by one according to the sequence. How I can overcome this problem.

...

You most likely have a data file saved into the acquisition method. We would advise you give a call to your local Agilent Software Support office.

You most likely have a data file saved into the acquisition method. We would advise you give a call to your local Agilent Software Support office.