LC/MS

Forum Instrument configuration on QQQ 6490 LC/MS MassHunter

State Not Answered
Replies 3 replies
Subscribers 86 subscribers
Views 1349 views
Users 0 members are here

Options

Related

Agilent Knowledge Portal

Find maintenance, best practice, and troubleshooting articles.

Agilent Knowledge Portal

Instrument configuration on QQQ 6490 LC/MS MassHunter

danielchsny over 1 year ago

Hello

Today our PC died and we decided to move to a new PC.

All CDs we had were MassHunter 10.1. So, my first question is: are these enough to make the LC/MS system run?

I installed Mass Hunter Acquisition. When I tried to run it, it said the instruments are not configured.

I do not see Lab advisor or other known software. I found one software under Tools: " Instrument configuration"

I tried to include infinity1290 and MS6400 series but give an error.

Any has a manual or instructions to install hardware? Am I missing any software?

Thanks

0 danielchsny over 1 year ago

UPDATE: I updated the configuration of the ethernet card dedicated to the LC-MS. Assigned a manual IP address. Remove all the restrictions from the windows firewall.

I followed the guides: G3336-90036_Windows_10_Setup_C.pdf and SD-89000976_MassHunter_SW_Installation_B.02.pdf

Now, I can ping the instruments:

Ping 192.168.254.11 to communicate with the LC

Ping 192.168.254.12 to communicate with the MS

I talked to Agilent, they said I still need to configure the instrument. This is not in the previous guides.

Anyone has this guide, using mass hunter software?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 m4esti over 1 year ago in reply to danielchsny

Hi,

Which guide are you looking for?

The install guides should be on the Acq install dvd.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 danielchsny over 1 year ago in reply to m4esti

Hi

Thanks for answering!

Actually, the answer was in G3335-90255EN
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?