LC/MS

Forum Tuning no signal

State Verified Answer
+1 person also asked this people also asked this
Replies 5 replies
Subscribers 86 subscribers
Views 3024 views
Users 0 members are here

Options

Related

Agilent Knowledge Portal

Find maintenance, best practice, and troubleshooting articles.

Agilent Knowledge Portal

Tuning no signal

ANME over 3 years ago

Hi

After running the APCI tuning checktune, autotun -dual on our HPLC-MS, the MSD cannot find the signal. They more look like noise and fails the tuning.

Can anyone givee a suggestion?

Top Replies

m4esti over 3 years ago +1 verified

Hi, Put on ESI source and run a manual tune to see if you see peaks. If not, make sure u see spray.

Parents

+1 m4esti over 3 years ago

Hi,

Put on ESI source and run a manual tune to see if you see peaks. If not, make sure u see spray.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Reply

+1 m4esti over 3 years ago

Hi,

Put on ESI source and run a manual tune to see if you see peaks. If not, make sure u see spray.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Children

No Data

Was this helpful?