How to fix the issue as the fog on surface of Transport G7129


I have a question,

I'm using ALS G7129 with sample cooler, I have a setup the temperature about 5oC. But when I set up to this temperature, ALS always have an issue as the fog stagnated on the surface transport ( picture attached), and sometimes ALS did'nt recognize sample tray. This causes serious problem when I have to run the sample overnight, because the sequence will stop suddently at anytime. Otherwise, I'm afraid that when water stagnated on the surface of transport, it'll affect the operation of the transport in the future. So, How to fix this issue?


Parents Reply Children
No Data
Was this helpful?