Hi,
I am trying to run an injector program on an Aglient 1260 Infinity II using OpenLab 2.5. I can setup the program but cannot get it to run.
Any help would be appreciated.
Thank you
Find maintenance, best practice, and troubleshooting articles.
Hi,
I am trying to run an injector program on an Aglient 1260 Infinity II using OpenLab 2.5. I can setup the program but cannot get it to run.
Any help would be appreciated.
Thank you
Can you provide any more information? Perhaps some pictures showing the injector method that you are trying to run, and how you are going about setting it up.
Hi,
Through the dashboard I am right clicking the Sampler, and then selecting injector program.
This is the program I have set up.
After doing this though, I cannot find where to run it.
Thanks
I see what you are doing now. Better to go home then method and then click on sample prep. Then put your injection program into this and save it. This saves it as a .smx file. Then you add the .smx file to the single sample or sequence as I explained below.
Thank you
Thank you