Injector Program

Can you provide any more information? Perhaps some pictures showing the injector method that you are trying to run, and how you are going about setting it up. 

In OpenLab 2.5, you have created your sample prep method (.smx) file. You can add this in single sample under sample prep method or in the sequence table as sample prep method. See my screenshots.

Hi,

Through the dashboard I am right clicking the Sampler, and then selecting injector program.
This is the program I have set up.

After doing this though, I cannot find where to run it.

Thanks

I see what you are doing now. Better to go home then method and then click on sample prep. Then put your injection program into this and save it. This saves it as a .smx file. Then you add the .smx file to the single sample or sequence as I explained below. 

Thank you