baseline offset 5973

kfc 10 months ago

The chromatographic baseline using my 5973 is consistently cut off and below the observable window for both the acquisition mode and post-run views. Is there a setting to adjust the baseline location (moving it up into the observable window) so that it is observable?

Top Replies

garyb007 6 months ago +2

Yes you can edit the method and set the Y scale in the MS parameters screen. Also you can click on the up and down arrows on the left side anytime even as it is running to bring things on screen.

0 CMZainea 6 months ago

Hello kfc ,

Sorry for the delay in response to this. I am moving this to the GCMS forum, as it is a better fit there.

What is the Software type and version you are using?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 garyb007 6 months ago

Yes you can edit the method and set the Y scale in the MS parameters screen. Also you can click on the up and down arrows on the left side anytime even as it is running to bring things on screen.
Cancel
Vote Up +2 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?