• State Verified Answer
  • +2 person also asked this people also asked this
  • Replies 24 replies
  • Answers 2 answers
  • Subscribers 12 subscribers
  • Views 6854 views
  • Users 0 members are here
Related

Agilent Knowledge Portal

Find maintenance, best practice, and troubleshooting articles.

Agilent Knowledge Portal

GCMS tuning stopped 5975C

louh

Hello All,

I'm seeing an issue that I haven't come across before - have just changed the column and pumped back down yesterday. Came to do an air and water check this morning and i get the below: 

Tune action stopped:-222{SP00}:MSC:RDY ON Parameter ento value 64.256 out of range [0.000, 64.000]

I didn't do anything with the source yesterday, just changed the column....

Thanks in advance!

  • 0 in reply to ISH

  • 0 in reply to ISH

    Or if you no idea then better call to your local agilent support to log service call...

  • 0 in reply to paulsalverda

    I tried to add the tune reports as pdfs but couldn't upload.... Thanks both ISH and paulsalverda for your replies, we got the system second hand so I don't have a 'local' agilent engineer I can call on! I have no experience of removing and cleaning the source of this system but it is looking likely I'll need to. 

    The curious thing is that the only difference between the good tune a week prior and the bad tune last week is that I had to vent and clear some debris out of the analyser chamber...I didn't actually touch the source or run any samples so its strange that suddenly the tune has an issue :(  

Was this helpful?
Privacy Statement
Terms of Use
Contact Us
Site Help