ICP OES 5900 SVDV Water Cooling Issue

Question

Hello, randomly the status light for water cooling will not turn green upon turning on the chiller. Per the instrument troubleshooting I removed the water cooling filter, cleaned and replaced it. I ran a chiller performance check and all steps passed. I noticed on the dashboard the peltier won't cool below 26.4C. I also see that the camera water flow is 0 L/min. Does anyone have any insights or has experienced this problem before?

CGS · Answer

Hello Ricrob612 
 Although plasma is OFF, there should be flow in CCD path, around 1L/min. So, it means issue could be related to water sensor CCD in water manifold assembly. 
 You can unplug the enter hose and check if the water is coming into ICP. If this is ok, the problem should be related to sensor. 
 On the other hand, you can access as Service from Heating/Cooling tab to check if the Oscillator Flow is 0 l/min too, but you need a password, so in this case you have to contact with you Contact Center Support 
 
 Thanks 
 Regards

cschulz · Answer

Hi Guys, 
 I recommend to use the Agilent Cooling Fluid, as it inhibits algae growth and has a low conductivity. 
 https://www.agilent.com/store/productDetail.jsp?catalogId=5799-0037&catId=SubCat2ECS_1051508 
 If your Water manifold is blocked because of algae, and you have not filled the chiller with our recommended fluid, keep in mind, that this can cause the loss of warranty. 
 
 best regards 
 chris