This Information Applies To: Agilent OpenLab ChemStation software
Issue
The pump can be set to a low rate after completing a sequence using a shutdown method in the sequence. However, to avoid solvent overconsumption and lamp wear-out, the OpenLab ChemStation software can be programmed to shut...
This Information Applies To: Agilent OpenLab CDS 2.x controlling Agilent LC Systems
Issue
This article outlines an instruction on how to submit a shutdown method on OpenLab CDS 2.3 or above.
Background
Submit a shutdown run to the run queue that will shut down Agilent LC instrument after...
This Information Applies To: Agilent OpenLab C DS software (Rev. 2x)
Issue
If the column configuration has been defined in the method, the instrument will calculate the pressure to maintain the target column flow rate. The column configuration must be edited or calibrated when a new column is installed...
This Information Applies To: Agilent OpenLab CDS
Issue
When trying to launch the OpenLab Control Panel, the error "connection to server failed". The issue could happen when users created in the OpenLab Control Panel and these users are coming from a Domain. Both File System mode and Content Management...
This Information Applies To: Agilent OpenLab CDS
Issue
Procedure to define E-Signature levels in your OpenLab CDS.
Background
E-Signatures allow the users of Agilent OpenLab CDS to define a review/approval process for a Result Set. One look at the signature data quickly and clearly identifies...