This Information Applies To: Agilent SpectrAA Software
Issue
There are three different ways to generate reports in SpectrAA Software.
Generating a Report from Stored Data
Automatic Report Generation During a Worksheet Run
Automatic Report Generation After a Worksheet Run
Requirements...
This Information Applies To: Agilent Spectroscopy Systems, SpectrAA Software
Issue:
When the Open Worksheet action is selected in SpectrAA Software, the file is opened from the default path (location), which is: C:\ProgramData\Agilent\sp100\DATA. See Figure 1 . A different file path may be chosen...
This Information Applies To: Agilent SpectrAA Software
Issue:
Explanation of concentration results flags from SpectrAA Software
Under certain conditions, a concentration result may appear with a concentration result 'Flag'. The following table lists each possible concentration result flag and...
This Information Applies To:
Agilent Spectroscopy Systems (AA50,55,240,280)
Issue:
Typical QA/QC procedures demand calibration through several steps including running interference check samples, calibration verification, running calibration standards, and determination of linear dynamic range...
This Information Applies To: Agilent Atomic Absorption systems with SpectrAA Software 5.x
Issue:
Following Adobe Flash going out of support as of 31 December 2020, Adobe has disabled the Adobe Flash Player as of 12 January 2021. SpectrAA uses Adobe Flash for the start screen.
This procedure outlines...