Hi!
Due a change to OpenLab CDS C.01.10 the setup of the sequence changes.
For the old Version i setup a Sequence with a macro using the commands:
SetTabVal _SEQUENCE, T$, R, "Vial", Vial
Where T$ is the "SeqTable1" od "SeqTable2". So i can set up a list for front and back and then start the sequence.
In Version C.01.10 the Sequence is one table for front and back injections and i can not find the macro commands for that. Using the old procedure will fail because of:
- I can not set the Sequence Table to "Dual Simultaneous Injections"
- The "Injector Location" is always front, i can not change it to back.
I think there are two different ways of solution:
- There are new macro commands i don´t know to activate "Dual Simultaneous Injections" and setting the "Injector Location" to front or back. Does anybody know the macro commands for that operation?
- It is possible to load XML Woklists for Front and back (Menu Sequence: "Import Worklist (Front)" or "Import Worklist (back)"). Does anybody know the macro commands for that operation?
Thanks ins advance!