Hi I work on qTOF 6546.
Accoring to the "F1- help" in Mass Hunter for 6546 model I can not use the slicer position in high sensitivity mode. The same information was itroduced in one of Agilent webminars.
However on Agilent comminity I got answers tht people use the high sensitivit slicer position duing their analysis on 6546.
The question is: Can I use the slicer posiotion in qTOF 6546?
Maybe the tune shpul be done in high resolution mode but druring analysis i can use high sensitivity position?
Thank you for your help.