What should I go on my software when the module has been exchanged through an instrument exchange program?

Question

When an LC Module has been exchanged, what should be done on my OpenLab CDS? Shall i change something so it works out?

jhagel · Answer

Yes, you will need to go into the Open Lab Control panel and reconfigure the module. It is in the help as well- OpenLab Help & Learning (agilent.com) 
 The default ip address is 192.168.254.11 
 Make sure that you have the correct info for each module- In case you have a larger loop or metering head etc. If you need assistance, please call your local Tech support and we'll be able to assist. 
 Note: When you request an exchange, you will also want to make sure the new module has the same firmware.

What should I go on my software when the module has been exchanged through an instrument exchange program?

Top Replies