Hi everybody, I'm working on a 1200 HPLC, and I noticed that the z-axis movement of the autosampler arm (G1329B) is not normal, there is some vibration. Is there a solution to this problem?

AutoSampler G1329B problem

Parents
  • Hello,

    If there is a vibration to the movement, make sure that it is not obstructed in anyway, it may be sign that there is some obstruction and the arm has issues moving.

    Other than that, you should call local tech support or your local engineer to have someone onsite. They may need to replace some parts if you do not see any obstruction.

    Kind Regards,

    Gabriel

Reply
  • Hello,

    If there is a vibration to the movement, make sure that it is not obstructed in anyway, it may be sign that there is some obstruction and the arm has issues moving.

    Other than that, you should call local tech support or your local engineer to have someone onsite. They may need to replace some parts if you do not see any obstruction.

    Kind Regards,

    Gabriel

Children
Was this helpful?