Hey guys,
The last couple runs, the sequence stopped due to the autosampler arm's motor getting overheated (error code: Motor overtemp [EE 4027, > 70 1da9 5cd20049 0 ). Are there any steps I can take to fix this issue? It's a G1313A.
Thanks,
B
Find maintenance, best practice, and troubleshooting articles.
Hey guys,
The last couple runs, the sequence stopped due to the autosampler arm's motor getting overheated (error code: Motor overtemp [EE 4027, > 70 1da9 5cd20049 0 ). Are there any steps I can take to fix this issue? It's a G1313A.
Thanks,
B
Hi B,
You may need to leave the sampler off too cool down and try again. After you let it "cool down how many injection do you get through?
What version of software and firmware are you running?
The transport may be wearing out.
Hi B,
You may need to leave the sampler off too cool down and try again. After you let it "cool down how many injection do you get through?
What version of software and firmware are you running?
The transport may be wearing out.