How to show all loaded signals in one report chemstation

Chemstation version is c.01.09 (144)

We are trying to get both our front and back signals to show up in one report. Right now we have to pull up the front calibration then the back calibration separately. How can we combine these so after recalibration we only replace the level once instead of separately for both. Same applies for the check standards, we have to load them separately.

Little more info, we have this capability on our 7890 GCs we also run, it's called signal assignments, but we don't see this anywhere for our 6890N but the software is all the same.

Thank you.

Was this helpful?