Hi everyone!
I would like to know if it is possible to remove "No Data Found!" from the intelligent report
I select the DataAnalysis Method Information to show my Integrator
Find maintenance, best practice, and troubleshooting articles.
Hi everyone!
I would like to know if it is possible to remove "No Data Found!" from the intelligent report
I select the DataAnalysis Method Information to show my Integrator
Hi yurisarmento
Is that from a table above that report item? I think that's probably in the advanced properties of the report item above. You can choose what to display if there's no data available.
/Andy
Hello,
As Andy stated most objects in IR have an advanced tab in their properties where you can determine the behavior when empty.
Marty
Hello Martin and Andy! I found out what were wrong. In my sequence two injections doesn't have a DA Method linked. When I pin only the injections with DA Method linked, the "No Data Found" was gone.
Hello Martin and Andy! I found out what were wrong. In my sequence two injections doesn't have a DA Method linked. When I pin only the injections with DA Method linked, the "No Data Found" was gone.