Is it possible to remove "No Data Found!" from intelligent report?

Hi yurisarmento 

Is that from a table above that report item?  I think that's probably in the advanced properties of the report item above.  You can choose what to display if there's no data available.

/Andy

Hi yurisarmento 

Is that from a table above that report item?  I think that's probably in the advanced properties of the report item above.  You can choose what to display if there's no data available.

/Andy

Hello,

As Andy stated most objects in IR have an advanced tab in their properties where you can determine the behavior when empty. 

Marty

Hello Martin and Andy! I found out what were wrong. In my sequence two injections doesn't have a DA Method linked. When I pin only the injections with DA Method linked, the "No Data Found" was gone.