Cannot get missing summed peak(s) to report.

Hello,

I'm trying to get a report template that will report the % area of 3 summed peaks regions. Using the "Compound Results" table, I am able to get my summed peaks to report % area, however if one of the summed peaks region contains no peaks, that region will not report on the table. I need components to report, even if they are nonexistent. I've tried going into the table properties, and setting the filter "missing peaks" to "on," but it still does not report missing peaks. Does anyone have an idea on how to get my summed peaks to report even when they don't exist?

I am using OpenLAB CDS ChemStation Edition - Rev. C.01.06[61]

Any and all help is appreciated, thank you.

0 martin.adams 1 month ago

Hello,

In Chemstation IR , the timed groups will not show up if no peaks are found in that time region. This is more because of how Chemstation handles timed groups than the reporting engine. You can see in the CDS 2.x a timed group with no area does show in the reports.

Marty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ColeFunk 1 month ago

I'm using a different version than you so this may not be applicable, but it is worth a shot. In the default "Compound Results" table, it filters out missing peaks. You can include this by opening up the table properties, going to the tab labeled "Peak Filters" and checking the box that says "Missing Peaks" so that they are included.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?