ACAML invalid/missing checksum after sequence aborted

I'm using OpenLab CDS and unable to load data after a sequence was aborted. When attempting to load data from this sequence I receive an error stating that the .acaml file has an invalid or missing checksum. If anyone has a workaround, I'd appreciate it.

Parents

0 martin.adams 2 months ago

Hello,

It depends on the version of the CDS software, if you have CDS 2.5 or later, try rebooting the AIC or workstation when possible. This may allow the remaining data to upload and the ACAML to be repaired depending on the original issue. If this does not resolve the problem open a ticket with your local Agilent support if you are a workstation customer. If you are a client server customer, you should be able to open a ticket with Agilent informatics support.

Marty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 bug_scents 2 months ago in reply to martin.adams

Thanks, the informatics team was able to repair the file, but rebooting the AIC will be good to know in case I encounter this issue again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 bug_scents 2 months ago in reply to martin.adams

Thanks, the informatics team was able to repair the file, but rebooting the AIC will be good to know in case I encounter this issue again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Was this helpful?