Hello
I have run a number of samples of unknown concentrations for an antibody, I was given a purified antibody with known concentration to create a standard curve. When I go to create my calibration table I end up getting a warning message stating that my standards have the same peak RT. Just so I understand when creating a standard curve in OpenLab CDS do you setup a sequence run so each injection has a different amount and then associate each level to that injection amount?
Hello,
It looks like you already have the answer. You would have one compound in the peak table with levels defined for each of the compound concentrations you will be injecting to build the curve. In the example below, I have one compound with 2calibration levels that I have injected as replicates in the result set.
Marty Adams
Hello,
It looks like you already have the answer. You would have one compound in the peak table with levels defined for each of the compound concentrations you will be injecting to build the curve. In the example below, I have one compound with 2calibration levels that I have injected as replicates in the result set.
Marty Adams
