Hi,
I am creating a calibration curve report with the Calib Curve by Compound.
I want the value for A to be the average of six standard injections. Currently, it is displaying the value of the final standard.
How can I get it to display the average value?
Also, is there a way to show the multiplier value (standard concentration) within the report?
Thanks,
Gabriel
Hello,
When you created the curve in the injection list did you clear the curve on the first standard injection and then leave the other injection run types blank?
Marty Adams
\
Hello,
You might want to check in DA that the calibration curve is using all the points. It is easier to find this if you set the method to use individual points. Also, for earlier versions than 2.5 make sure you are displaying the calibration report for the last standard or an injection after the standards.
Marty Adams
Hi,
Thanks for all the help so far. I tried using the individual calibration points, but it did not change the outcome.
I'm hoping by providing some more screenshots it will help.
Here is the calibration curve and the calibration report with average by level.
Here is the calibration curve and the calibration report with individual calibration points.
Hello,
You are reporting the correct coefficient from the calibration curve. The RF column is not the actual RF used for that injection in the calibration as that would be ~12831.14 it is the calculated RF based on the calibration as below. I cannot show the exact recalculated RF of last standard in the excel as I do not have the full value for the calculated amount (0.2174). The last standard injection calculated RF should be the same as the slope in the case of a single level calibration.
Marty Adams
Hello,
You are reporting the correct coefficient from the calibration curve. The RF column is not the actual RF used for that injection in the calibration as that would be ~12831.14 it is the calculated RF based on the calibration as below. I cannot show the exact recalculated RF of last standard in the excel as I do not have the full value for the calculated amount (0.2174). The last standard injection calculated RF should be the same as the slope in the case of a single level calibration.
Marty Adams
