Openlab CDS Rev. C.01.10(201) report formatting issue

This report and formula  was set up by my predecessor.  I'm actually not familiar with setting up a compound custom field for the carbon numbers, but I have set up basic reports in Openlab on another system. 

If you could guide me on this, I would greatly appreciate it.

You can add custom fields to your Chemstation methods, both sample and compound custom fields. Then you can enter the custom information when creating the sequence. The other options would be to use one of the methods outlined in the post I linked below. We discuss using part of the compound name to enter the constant information or using custom code and an external constants file. 

(+) Compound LOD and LOQ in OpenLab CDS-Chemstation - Forum - Chromatography Software - Agilent Community

Here is what I have:  

I don't see the compound custom fields.  How do I get that tab to come up?

Hello,

Does your method have peaks in the calibration table? You cannot have compound custom fields entries without named peaks in the calibration table.

Marty Adams

That's the calibration table.  All the peaks are named.  Is there something else I'm supposed to do?

[Personal Information Removed by Moderator]

 Sean_NCGOV ,

If you feel you need assistance beyond what can be provided in the Community, please contact your local support team for assistance. Contact Us | Agilent

Hello,

As Howard said if you need more direct assistance, please contact your local support team. You should see the compound custom fields in the sequence as you have the method setup. One thing I can think of is if you did not update the master method with the calibration table. Another possible issue is you cannot add custom fields to data that has already been collected. The custom fields must be part of the method when the data is acquired. It looks like the sequence table you are displaying might be from an existing data set. 

Marty Adams

Hello,

As Howard said if you need more direct assistance, please contact your local support team. You should see the compound custom fields in the sequence as you have the method setup. One thing I can think of is if you did not update the master method with the calibration table. Another possible issue is you cannot add custom fields to data that has already been collected. The custom fields must be part of the method when the data is acquired. It looks like the sequence table you are displaying might be from an existing data set. 

Marty Adams