How do I export only the signal and retention time from multiple samples as a .csv or .xcls file?

Hi awiteof,

Check out the link.  I wrote a macro to export all signals.

Post-run Macro to export Signal Raw Data to ASCII 

Tim

Thank you Tim! Before you responded we were trying to implement a macro on our own, with limited success. We tried yours and it worked perfectly on the first try! We all very much appreciate your response! You have made a lot of grad students/techs very happy. Have a good week.

Thank you Tim! Before you responded we were trying to implement a macro on our own, with limited success. We tried yours and it worked perfectly on the first try! We all very much appreciate your response! You have made a lot of grad students/techs very happy. Have a good week.

Glad to hear it.  Let me know if there are any problems that arise.

Did you understand the conversation on the original thread.  I added (LoadFile dadatapath$ + dadatafile$) at the beginning because the original poster was capturing signals and not using them in any reports so I had to first reload all the signals and then export them.  You could remove that line if all the signals you are capturing have been added to the Signal Details section.

Tim