Calibration for Front and Back Signal

Hi DOT

You need to add one compound for each column.  They need to have different names, so you might have CompoundA Front and CompoundA Back, as the compound names.

Kind regards

Andy

Hi Andy

Thank you very much for your help. I could add the compounds, however, when I add new levels (concentrations) for the calibration curve, the software does not accept multiple insertions at the same level. Do you know how to solve that problem?

Thank you 

DOT

Hi DOT

Can you tell me which version of OpenLab CDS you are using?  The last comment suggests that you're running OpenLab Chemstation Edition.  My answer will be longer, if you're working with OpenLab Chemstation Edition.

Maybe you could post a screenshot so that I can see where you're struggling.

Kind regards

Andy 

Hi Andy

Yes, I am working on OpenLAb Chemstation Edition (see picture attached). My problem is, that I only can make one calibration for either front or back. Adding additional concentrations of the Back-signal did not work.

Thanks for your help

DOT

Hi Andy

I finally could solve the issue. I was confused about the levels. By adding new levels I could calibrate both peaks. Thank you for your help and have a nice week.

DOT

Hi Andy

I finally could solve the issue. I was confused about the levels. By adding new levels I could calibrate both peaks. Thank you for your help and have a nice week.

DOT