Am I not able to perform a manual injection using OpenLab Chemstation? If so where is the prompt to start the run after the injection has been made?
Find maintenance, best practice, and troubleshooting articles.
Am I not able to perform a manual injection using OpenLab Chemstation? If so where is the prompt to start the run after the injection has been made?
Hi there, Laurenairchecklab !
I run on an ALS, so manual injections aren't really my bag. But , if you look at your sequence you should see a column labeled something like "injection source". Is the entry in that column "manual injection"? You have, I believe, three different choices: one "per method", one "gc injection" and one "manual injection". That might be your problem.
I usually run on ALS but don't have one for the current instrument in question. I looked at the injection source and only see external or no injection/instrument blank.
Go into your sequence table and check out the injection source column and see what options it gives you. Mine give me this:
Does this look like what you're getting?
not exactly for the injection source i only see external or no-injection/instrument blank
Hi laurensnyder
Sounds like you're using OpenLab CDS not Chemstation. I would have expected selecting External would allow you to do manual injections. I can't work out what sort of instrument your using.
/Andy
by saying ChemStation to OpenLAB CDS I meant that I was transitioning from one to the other. I. was able to select external injection on the sequence and initiate it by pressing start on the instrument keypad. thank you.
by saying ChemStation to OpenLAB CDS I meant that I was transitioning from one to the other. I. was able to select external injection on the sequence and initiate it by pressing start on the instrument keypad. thank you.