Post-run Macro to export Signal Raw Data to ASCII

Hi Amedeo,

Attached is a more complete macro for you.  It will export multiple signals and place the ASCII file in the samples data directory.

Just put the user.mac file in the C:\Chem32\Core directory and add the "EXPORTSIGNALS" macro to the post run macro in the runtime checklist.

Let me know if you have any problems.

Tim

Hi hebgent!

I tried your macros but keep getting parser errors.

user.mac and extractsignal.mac are both placed in the CORE directory.

Extractsignal.mac is set as the postrun macro.

I have also tried user.mac as the postrun macro and have tried them both from the command line.

There is always a parser error.

We are using the latest release of Chemstation.

Currently, I have 3 signals; 2 from the DAD and one from the FID.

Any thoughts?

Thanks!

I've tested it with sequences and it appears to not work correctly. 

Let me know if it works for you.

Could you attach the signal1 csv file so I can look at it.

I'm pretty sure a sequence won't work with the macro I've supplied.  I'll need to look into fixing it.

Could you try and run a single sample and see if you get all 3 signals.

Tim

I got it fixed.

Attached is a new user.mac file. Just replace the other 1 with this 1 and then shutdown and restart Chemstation to load the new macro.

Tim

I have runs going on all of my machines.

When they are done tomorrow morning, I'll give it a try and let you know how it worked.

Thanks again!

Just loaded the new user.mac and reprocessed some data.

Signal1   correct (DAD1A)

Signal2   not correct. It is giving me the gradient pump, not DAD1B (it was not correct on the previous version either). 

               I don't mind getting an extra csv file that contains the pump gradient. It is useful.

Signal3 is not present. Signal3 should be the fluorescence detector data.

Maybe the different channels from the DAD and FLD are in different data files or locations from where you are parsing it out?

Is there a data file from Chemstation that I can send you that might have the raw data in it?

I don't think the currently generated  Signal1 and Signal2 files would help you, they are simply time and signal comma delimited for 1 channel each.

I'm sure if I send a file from a blank run, nobody will care...

The macro exports data in the ChromReg register but only the signals listed in the Signal Details of the method are loaded into the register.  So by adding all the desired signals to the Signal Details of the method you will get each exported.  Or if you don't like doing that because of how it changes the default reports we can reload the sample data file at the start of the macro which will load all signals.

You are correct, the FLD is stored in a different register.  I'll work on adding that register to the macro.

Tim

The macro exports data in the ChromReg register but only the signals listed in the Signal Details of the method are loaded into the register.  So by adding all the desired signals to the Signal Details of the method you will get each exported.  Or if you don't like doing that because of how it changes the default reports we can reload the sample data file at the start of the macro which will load all signals.

You are correct, the FLD is stored in a different register.  I'll work on adding that register to the macro.

Tim