I have issue withe 8453 power switch led on , front panel led on (red light)
after verification the both lamps are not on..
how i can check the sls board or what i can check ?
THANKS I
I have issue withe 8453 power switch led on , front panel led on (red light)
after verification the both lamps are not on..
how i can check the sls board or what i can check ?
THANKS I
Hi
First replace lamp then check...
both lamps are new, the problem appeared after replacing the lamps and dusting the instrument
Then i have a doubt that may be lamp power supply source is not okay.
If you can help from below documents then okay, otherwise, i will suggest to call your local agilent support to check it onsite.
Again check all the connector of lamps..
In my case i need the change the SLS BOARD ? before proceeding of alignment
In my case i need the change the SLS BOARD ? before proceeding of alignment
Changing SLS Board is service job..so need to call your local agilent support..