MassHunter and GC 6890N

Hi Dear,

I have a GC (6890N-FW 06.07)-FPD-MS (5975) and controlled by Chemstation (G1701EA). Program software upgraded to MassHunter (B.07), windows 10, 64bit.

When I use GC-MS (without FPD), The instrument work properly; But in the case that the FPD detector is turned on and the save data tick is ticked, after the end of the data acquisition, the saved file is not opened in quantitative software and an error message is issued.

What is the problem?

Best regards

Was this helpful?