Displaying LOD LOQ mass Hunter Quantitative 10.2

Question

Hello, I m working with Mass Hunter Quantitative 10.2 and i made several calibrations Sim Mode and analysed them with Mass Hunter. Then regressiosn are calculated abd i saw that it s possible to display LOD AND LOQ (columns available) on batch table. 
 
 But those columns are still empty after LOD and LOQ choosed. Any idea or solution? 
 Thanks a lot

howard_sanford · Accepted Answer

Hello Lstephan , 
 To populate the method LOD and LOQ columns you need to assign a limit to the method outlier. This can be done in the Method Editor under Outlier Setup. 
 
 After a method limit is set it will be displayed in the batch table. The flag will be displayed on the Calc. Conc. entry.

Displaying LOD LOQ mass Hunter Quantitative 10.2

Top Replies