Agilent 6890 GC Chromatography, Pneu Error 0012, Loss of Inlet information

Hello everyone

I had a problem with gc chromatography.

When I turn on the device, I see the message "Pneu Error 0012, PCB Cmd Error:2003".

And when I run the software through the computer, I can't see the information about the inlet.

Only the information about the temperature setting is visible, and it exists in an unknown state.

Currently, I can't use GC due to such an error, so I'm leaving a message on the forum if I can get help.

Thank you for reading this.

           

Was this helpful?