Agilent 8890 GC User Manual - Available in French?

hello, if possible I ask for the user manual in French of the agilent 8890 Gc system machine because after cleaning the injector and the ECD detector I still cannot have signal peaks.

Top Replies

ISH over 3 years ago in reply to ISH +1 suggested

community.agilent.com/.../8551.usermanual_2D00_gc_2D00_operation_2D00_8890_2D00_g3540_2D00_93014_2D00_fr_2D00_agilent.pdf

0 Maxmax over 3 years ago

Hello, I need help setting my baseline during ECD scans because I always find it on 10 × 6 which is not normal.
- IMG_20211015_113707.jpg
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ISH over 3 years ago in reply to Maxmax

I think, you should call to your local agilent to see it on site..

In picture, attached by you, inlet pressure is showing 0 psi..means no column flow or something else...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Maxmax over 3 years ago

I have done it several times but still no answer that's why I had the idea to join this forum, he told me the last time he was traveling for a job. more than a week.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ISH over 3 years ago in reply to Maxmax

https://community.agilent.com/knowledge/gc-portal/w/gc-knowledgebase/8512/ecd-baseline-troubleshooting

Check this link for baseline troubleshooting...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Maxmax over 3 years ago

Hello, I need help with my hydrogen machine which has been warning me of a failure since last night I would like to know if you had any idea of the failure, here is the picture.
- IMG_20211022_091948.jpg
- IMG_20211022_091955.jpg
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ISH over 3 years ago in reply to Maxmax

Hi

This is not Agilent instrument.

Check with peak scientific( manufacturer of instrument)..
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?