flame problem

Question

Hello, 
 
 The flame goes out as soon as the detector stabilizes at 2 pA, and it turns on again and then re-opens with my GC8860. I think the problem comes from the LIT offset value, however impossible to change this value with my interface. I have to choose [Settings]> [Configuration]> [Detector] but I don't have the [Configuration] tab (from the device's IP address). 
 
 Thanks for your help 
 
 CL

wcody · Accepted Answer

The lit offset can be adjusted from two different locations, one is from the software on the method parameter page and the other is through the front screen of the 8860 itself. For the software if you are using CDS 2 you may need to open the Configuration window when viewing the FID parameters. Below are instructions to change the lit offset from the front panel of the 8860.

flame problem

Top Replies