GC Portal

GC Portal Article Search

Filter by:

Performing a GC/MS Manual Injection Using MassHunter Software

This Information Applies To: Agilent GC/MS systems using MassHunter software Issue Manual injections are needed for a GC/MS without an automated sampler. They are also used for troubleshooting specific issues such as no peaks, lower peaks than expected...
Replacing the Gas Clean Filter

This Information Applies To: Agilent GC systems with Gas Clean Filter Issue If you have determined that the Gas Clean Filter is saturated, it mus be replaced (see the article When to Replace the Gas Clean Carrier Gas Filter ). The steps described...
Recommended GC Column (Carrier) Gas Flow Rates

This Information Applies To: Agilent GC Systems 8890/8860/Intuvo 9000 /7890/7820/6850/6890 Issue General guidance on GC column flow rates, outlining the correct column flow rate for optimal compound separation depends on the column internal diameter...
Translating Methods with the GC Method Translator

This Information Applies To: Agilent GC Method Translator Issue Detailed instructions on translating methods using the GC Method Translator. Background For ideal use of cases and applications with the GC Method Translator, see the article...
Using the Solvent Vent Calculator

This Information Applies To: Agilent Solvent Vent Calculator Issue The Solvent Vent Calculator estimates the Agilent solvent vapor exit (SVE) accessory valve timing based on solvent type, oven temperature, vent flow, and pressure. Background...