How to use "Import worklist" function to import entries into the user defined "Amt. and Tot. Amt." column for LCMSMS?
How to use "Import worklist" function to import entries into the user defined "Amt. and Tot. Amt." column for LCMSMS?
Other info are import succesfully except the two ones. I tired "Amt.","Tot. Amt." in the importing csv file. Failed. "User1","User2" failed too. "Sample Amount","Total Sample Amount" also failed. Could you please kindly help me again? It is very important to us. Accordign to" How to make the amt && total amount available from worklist for LCMSMS masshunter Analysis Batch?", we can make the worklist && data analysis batch colabrate each other, But if the user defined "Amt. and Tot. Amt." column cannot be imported into worklist. It means nothing. Because we can input them mannually in the data analysis batch directly.
I apologize for the extremely delayed response. I was going through old posts and found that this one had never been replied to.
Just to close the loop on this post, I believe the answer to this question was discussed further on in the post How to make the amt && total amount available from worklist for LCMSMS masshunter Analysis Batch?
I apologize for the extremely delayed response. I was going through old posts and found that this one had never been replied to.
Just to close the loop on this post, I believe the answer to this question was discussed further on in the post How to make the amt && total amount available from worklist for LCMSMS masshunter Analysis Batch?