Communication of 1260 Infinity detector through RS-232

Hello Community

Is it possible to configurate a G1321B Fluorescence detector directly to a PC with CS B.04.03 [16] using a RS-232 cable?

I know that there is a PIN configuration in order to connect the module to a PC but I'm not sure if I can communicate and configure it with the CS software.

I appreciate your feedback on this regard.

Thank you very much

Top Replies

martin.adams 1 month ago +1

Hello, I am not sure as I do not have systems setup that are that old. It would be based on the driver from that version. Do you see the option for serial communication when configuring the HPLC in…

Parents

0 martin.adams 1 month ago

Hello,

I am not sure as I do not have systems setup that are that old. It would be based on the driver from that version. Do you see the option for serial communication when configuring the HPLC in B.04.03, if not then I would say serial was phased out by that point in the drivers.

Marty
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 martin.adams 1 month ago

Hello,

I am not sure as I do not have systems setup that are that old. It would be based on the driver from that version. Do you see the option for serial communication when configuring the HPLC in B.04.03, if not then I would say serial was phased out by that point in the drivers.

Marty
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Was this helpful?