Adding custom calculation results to report

Wael 2 months ago

Hello,

I'am currently using openlab cds v2.6 i have created a custom calculation files at the sequence scope it works perfectly but when adding the result to the final report it appears in all pages of the report is there a way to show the results separetly just on one single page ?

0 martin.adams 2 months ago

Hello,

Where did you add the field? If the object, you added it too repeats on each page, then it will be in each repetition. Also, if this is a single injection report and you use it for multiple injections, then the entire report will always repeat per injection.

Marty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Wael 2 months ago in reply to martin.adams

Hello,

I added it from custom calculation results table in the report template so it will be repeated in every injections ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 martin.adams 2 months ago in reply to Wael

Hello,

I do not know how you built the report. If the result is in a table, then it will repeat with the table. If your report was created as a single injection report, then the report would repeat per injection if you selected multiple injections.

Marty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Wael 2 months ago in reply to martin.adams

Hello,

Yes i have choosed a single injection report once creation, i will try changing the report type and see how it works
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?