How do I display peak noise in Chemstation report, with selected noise range?

Hi Lucie 

You can set noise ranges in Report... System Suitability... Edit Noise Ranges

/Andy

Thank you Andy, we will try this approach and get back should we have any more queries.

Thank you Andy, we will try this approach and get back should we have any more queries.

Good Morning, thank you very much for the suggestion on how to pull noise result through. We have managed to get noise to our report for the DAD signal, however the noise is not showing for any of the EIC channel. Could you help please?

Hi Lucie

Sorry for the slow reply.  I assume that the noise would be calculated if you had compounds identified in the EICs.  Isn't that the case?

/Andy

Hello Andy, the compounds are identified in EIC but unfortunately the S/N is not pulling through to the report. Is there anything else we should check?

Hi Lucie

I'm out of suggestions.

/Andy

No worries Andy, thank you for looking into it!