Hi, I am using Openlab CDS 2.6 and in my last run I forgot to set the run type for the first calibration point to Clear all calibration. Is there a way that i can add that after the run is over to create my new calibration curve?
Thank you,
-Sam
Hi, I am using Openlab CDS 2.6 and in my last run I forgot to set the run type for the first calibration point to Clear all calibration. Is there a way that i can add that after the run is over to create my new calibration curve?
Thank you,
-Sam
Hello,
The injection list will not be active in any of the default layouts. You will need to select the injection list from the ribbon to add it to one of the layouts. Then you can make the change as in the last reply.
Marty Adams
