How to add % recovery to calibration table in OpenLab version C.01.07 SR1

Question

I would like to add some information to the calibration table but am not sure if it is possible. I would like to add two columns: the calculated concentration of each calibration standard and the % recovery or difference from the true value. Currently the default table shows the Amount (true value of the standard), the Area in the standard and the Response Factor in addition to other info. I don't care about the RF and would be happy to remove that if I can get the concentration and % difference added. Thanks,

ryoboyle · Accepted Answer

Hello,

I added tags to this post to increase visibility.

I am not aware of a way to add those columns to the calibration table in ChemStation. Below is a screenshot of all available columns (accessed by going to Calibration>Calibration Table Options>Edit Options):

It is possible to display the residual for any calibration standard in a report like the Calibration.rdl default intelligent report template.

Hopefully that helps.

nuna0102 · Answer

ryoboyle I am struggling with the same question. How do I manually enter response factor? I am also wanting a % recovery column or difference between acquired value and true value. Also, should it not be Response/Amount?